| SLATTACH(8) | System Manager's Manual | SLATTACH(8) |
slattach —
slattach |
[-Hhlmn] [-s
baudrate] [-t
ldisc] ttyname |
slattach is used to assign a tty line to a network
interface which uses asynchronous serial lines.
Currently the slattach command is used to
attach sl(4) or
strip(4) interfaces. These
interfaces have to be created using the
ifconfig(8) The resulting
point-to-point link is not a broadcast interface and normally has a netmask
of 255.255.255.255. create subcommand before the
slattach command. The network source and destination
addresses and other interface parameters are configured via
ifconfig(8).
The following operands are supported by
slattach:
-H-h-l-m-n-s
baudrate-t
ldiscttyXX’, or
‘/dev/ttyXX’.Only the super-user may attach a network interface.
To detach the interface, use “ifconfig
interface-name down” after killing off the
slattach process.
Interface-name is the name that is shown by
netstat(1).
cu -t -F [hard|soft] -l /dev/dty00 ifconfig sl0 create slattach -l -t slip /dev/dty00
ifconfig sl0 inet 10.0.0.2 10.0.0.1 netmask 255.255.255.255
ifconfig sl0 inet 10.0.0.1 10.0.0.2 netmask 255.255.255.255
slattach command appeared in
4.3BSD.
slattach command. There is no way to see which
interface is assigned to the specified tty by the
slattach command, either.
It would be better if the network interfaces were created by the
slattach command rather than by using the
ifconfig(8)
create subcommand before the
slattach command.
| November 11, 2018 | NetBSD 9.1 |