| ESP(4) | Device Drivers Manual | ESP(4) |
esp —
esp0 at isa? port 0x230 irq ?
esp* at pcmcia? function ?
esp* at mca? slot ?
esp0 at obio?
esp1 at obio?
esp0 at obio0 flags 0x00ff
esp0 at obio0 addr 0x66000000 ipl 2 flags 0xff0f
dma0 at obio0 addr 0xfa001000 level 4 (Sun 4/300)
esp0 at obio0 addr 0xfa000000 level 4 (Sun 4/300)
dma0 at sbus0 slot ? offset ? (sun4c and sun4m)
esp0 at sbus0 slot ? offset ? (sun4c)
esp0 at dma0 (sun4m)
dma* at sbus? slot ? offset ? (Sbus)
esp* at sbus? slot ? offset ? (SBus, older PROMs)
esp* at dma? (SBus)
scsibus* at esp?
esp driver provides support for the NCR 53C90, 53C94
and 53C96; Emulex ESP100, ESP100A, ESP200 and ESP406; and Qlogic FAS216 and
FAS408 SCSI controller chips found in a wide variety of systems and peripheral
boards. This includes the Qlogic ISA and VLB SCSI host adapters, and the Sun
Fast SCSI buffered Ethernet for Sbus (FSBE/S, X1053A, Sun part # 501-2015).
For Qlogic PCI SCSI host adapters, use the isp(4) device.
esp driver supports the following
flags for use in
config(1) files:
“Target” is synonymous with SCSI ID number.
Note that SCSI tape drives should be allowed to perform disconnect/reselect or performance will suffer.
| December 3, 2001 | NetBSD 10.0 |